Location

Home>Products>Softboxes>Manual of Softboxes & Speedring

1. Name of parts

2. Assembling order of speedring in the type of
    softbox

3. Rear diffuser (the same way applies to both
    cover type and recessed type)

4. To attach the front diffuser

5. Putting strobe with softbox

6. Attach velcro tape at the back of softbox

 1. Name of parts

 

 2. Assembling order of speedring in the type of softbox

TYPES

MODEL

ASSEMBLING ORDER OF SPEEDRING

Rectan-
gular

Square

LBDM77, LBD(R)45,  66,  88,  1010

R1¡æR3¡æR2¡æR4

Regular Square

LBD(R)36,  68,  810,  912,  1014,  1218, 1420

R1¡æR3¡æR2¡æR4

Strip

LBD(R)39,  412,  612,  418

Strip1¡æStrip3¡æStrip2¡æStrip4

Octagon

LBO(R)90,  120,  150,  213

 

Be sure that upper side of a speedring (holes' name engraved) should face backward of softbox

 

 Before inserting rods to the speedring, please check names of hole on the speedring.

  Insert rods in diagonal direction and when inserting the last one, press it and insert as attached picture 1

 

 Take a rod and pull it by pulling upward as a picture 2

 After assembling, put it on flat floor and press them.

For rods to be inserted to the last

 

 3. Rear diffuser (the same way applies to both cover type and recessed type)

  Attach hooks in the middle of rods of softboxes to the hooks of a rear diffuser

 

  4. To attach the front diffuser

 

 

  5. Putting strobe with softbox

 

  Attach softbox to a strobe

  6. Attach velcro tape at the back of softbox

 

 Last, attach velcro tapes to block light